-
Telnet issues
I couldnt find a better place to put this but I am pretty sure it is related to the network or my PC somehow.
I am telneting into a Cisco 3750 switch and the timeout on the switch is set to 5 minutes.
It will randomly come up with the below message after a sporadic amount of time. It could be a minute it could be two.
It will also happen when I am in the middle of typing commands. It just started happening on my laptop and havent see it before. I dont know if it is happening to anyone else.
Code:
*
*
* Line timeout expired
*
*
Connection to host lost.
Specs:
Dell Laptop
Windows XP Pro
Hard wired into network
Tried from different VLANs
timing is sporadic < 5min
switch timeout is set to 5 minutes
Tried by doing Start>Run>cmd> telnet switchname
Tried with Putty
Same result on both
let me know what else you need to know.
-
couple of things could be wrong, bad cable, bad nic, bad switch port.. Are the speed/duplex settings correct? Try not to use auto/auto on both ends. Fixate the speed/duplex on the nic and the switchport..
Just some random things i would try :D
-
I think the first question would be if it happens from other systems on the network as well
-
Are you using exec-timeout or session-timeout? For troubleshooting purposes I would set your exec-timeout to 0 and see if you still get disconnected.
Example.
line vty 0 4
exec-timeout 0
-
Sorry for taking so long to get back... One of our other Net Admins does have the same issue. I have tried a different port, a different switch and tried both auto and 100/full.
I first wanted to believe it was an application issue until it did it with both putty and the telnet command.
Net2
My settings are as follows:
line vty 5 15
exec-timeout 5 0
Doesnt that mean it will timeout after 5 minutes?
-
I also am looking to see what others use for connecting to their switches.... Please dont ask me why we cant setup SSH on these switches.
[cynicism] apparently its a good idea to just throw every thing on the network in clear text.[/cynicism]
as stated i have tried just telnet and putty. looking for somethign a bit more robust
-
SecureCRT by Vandyke has always been a favorite of mine, but then again, it's not free though
http://www.vandyke.com/products/securecrt/index.html
-
What are your line settings for vty 0 4? Posting your whole configuration minus the actually ip addresses would be a great help.