HELP -Pix 501/Setup

[swarisd]

Your global command is wrong. You have:

Global (outside) 1 x.x.x.118 netmask 255.255.255.248

Well, from what you describe x.x.x.118 is another device. It should be the outside interface or whatever IP you want to use for PAT.

For kicks, try using

Global (outside) 1 interface

See if this works.

<EDIT>
I really wish I would have read all of the post instead of skimming, I would have noticed that everyone else agrees with the global command being wrong.

[micky05]

Thanks everyone for your input and advice. Everything is now working with the following changes:

Public network: x.x.x.112 255.255.255.248
Public router ip default gateway: x.x.x.118

Pix 501
Ethernet0 (outside) x.x.x.114 netmask 255.255.255.248

Previous x.x.x.117- Found that it was the Tel Router IP

Ethernet1 (inside) 192.168.0.10 netmask 255.255.255.0

Global (outside) 1 interface

was 1 x.x.x.118 netmask 255.255.255.248

nat (inside) 1 0.0.0.0 0.0.0.0 0 0

Route outside 0.0.0.0 0.0.0.0 x.x.x.118 1

Access-list acl_outbound permit tcp 192.168.0.0 255.255.255.0 any
access-group acl_outbound in interface inside

CAN - CONNECT FROM ANY HOST 192.168.0.0 TO ANY INTERNET
CAN - CONNECT FROM PIX TO ANY HOST ON 192.168.0.0 NETWORK

I struggled with crossover/straight-through cables to and from pix to routers and switchs. And for some reason I can't get a ping reply from the pix outside ip address if i ping it from 192.168.0.0 network. The problem I had with ip telephone was because I was told that its outside ip address was x.x.x.114 when in fact it is the x.x.x.117. I should have found it myself by simply ping x.x.x.117 with pix switch off.