-
January 11th, 2004, 02:35 PM
#1
Port Opening
I have a Prestige 600 series DSL/Router modem (according to the box it's both). Well I would like to know how do I open ports? Since some programs need some ports open to operate properly. When I connect to my DSL I have the following tabs:
Home
-Home
-Quick
LAN
-LAN Config
-DHCP Mode
-DHCP Server
-DHCP Relay
WAN
-DSL
-ATM VC
-PPP
-EOA
-IPOA
Bridging
-Bridging
-LAN Config
-DSL
-ATM VC
-RFC 1483 Interface(EoA)
Routing
-IP Route
-IP Addr
-LAN Config
-DSL
-ATM VC
-PPP
-EOA
-IPOA
Services
-NAT
-RIP
-FireWall
-IP Filter
-DNS
Admin
-User Config
-Commit & Reboot
-Image Upgrade
-Alarm
-Diagnostics
-Port Settings
I know the most obvious place to go to would be Port Settings but that is just to configure the normal ports ex: HTTP Port. I'm running Win2k pro although I don't think the OS has anything to do with it since I had the same problem on Win98.
-
January 11th, 2004, 03:01 PM
#2
-IP route should be it.
Setup a route that routes all incoming traffic on a particular port to your box.
The above sentences are produced by the propaganda and indoctrination of people manipulating my mind since 1987, hence, I cannot be held responsible for this post\'s content - me
www.elhalf.com
-
January 11th, 2004, 04:18 PM
#3
el-half is probably right. Here is what mine looks like as a reference:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|