September 16th, 2004, 04:05 PM
Genius HR6 USB problems!!! Need help!!
I have to say that before i came here i tried EVRYTHING that i could think of to try and install this scanner on XP Pro with SP1.
Iv downloaded the drivers from the site: Hr6a Hr6v2 Hr6x and nothing, non of them work!!!!!
The scanner it self is recognized by XP and i just point the folder were i have the Hr6 drivers and it installs it.
The problem is with the Keyscan and scan utility, it always says: scanner not found iv tried Hr6 USB, Hr6, Hr6 V2 Hr6v2 USB, Hr6x, Hr6x USB i dont know what elso to do
The stupid thing of all, is that once before, with XP i can remember that it worked...i really need to put this to work today and i dont know what else to do.
I did what they said on one read-me file, Umplugged the USB cable, install the setup.exe first, restart the PC, insirt the USB cable, install the driver but nothing
Can anyone help me out?
September 16th, 2004, 10:19 PM
Please ppl, its very important, i need help on this..!!!
September 17th, 2004, 07:28 PM
There are certain devices that XP just doesn't like. sounds like you've got one of them. You've got my sympathy - had to replace a sound card on my old box when I first upgraded to XP...then it didn't like the monitor, so I had to replace it too...go figure. Sorry but that's all the help I have to offer - if it doesn't work no matter what ya try, get a different one.
Even a broken watch is correct twice a day.
Which coder said that nobody could outcode Microsoft in their own OS? Write a bit and make a fortune!
September 17th, 2004, 10:20 PM
Well..if thats the problem, i have a much cheeper solution, format, install 98SE and them Install XP in dual boot..better than spend euros...hum right now the budjet its kinda low.
I tough about just smash it but..