-
October 1st, 2004, 09:05 PM
#1
Netbios Execution
Does anyone know if it is possible to remotely execute a program via netbios once it has been transfered to the remote machine ? Baring in mind that only special folders have been setup to share via netbios, not the whole system.
-
October 1st, 2004, 09:21 PM
#2
you'll need the the user/pass of the system, but you could use psexec.
-
October 1st, 2004, 09:39 PM
#3
psexec will still require the authentication to take place.... Until you are authenticated psexec will give you an "access denied".
Don\'t SYN us.... We\'ll SYN you.....
\"A nation that draws too broad a difference between its scholars and its warriors will have its thinking done by cowards, and its fighting done by fools.\" - Thucydides
-
October 1st, 2004, 10:02 PM
#4
Authentication will be needed, but you could use WMI or the AT/SOON command to run something remotely if you have the right permissions. NetBIOS is mostly just a naming protocol.
-
October 1st, 2004, 10:45 PM
#5
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|