-
April 26th, 2005, 12:45 PM
#1
RAID problem
Hi.
I testing raid now on one of my computers and now when I removing a disk, whole system hangup.
Exist some disk/raid check utility?
Do I need to send mdadm.conf and raidtab ?
==My OS==
Linux = Mandrake 10.1
RAID Type = IDE on Q-tec 340R raid card (working but fully not supported by linux)
// too far away outside of limit
-
April 26th, 2005, 12:47 PM
#2
What kind of RAID is it (striped, mirror'd, RAID 5)? And is your system hot-swappable?
It's very likely that the system won't run since the RAID is incomplete.
-
April 26th, 2005, 12:57 PM
#3
It is RAID 1
Both of disks are 10GB
It worked and I could files on raid disks but then when I begun to simulate failure it is stopped to work but not from begining, I did it by removing power from disk.
As I know IDE not supporting hot swap, but I conncted disk(that was disconnted) to Linux again efter power of it. And then usind "raidhotadd /dev/md0 /dev/hda1" in /proc/mdstat was showing when disk was recovered.
// too far away outside of limit
-
April 26th, 2005, 03:54 PM
#4
Can mdadm run only programs or it can run .sh also?
If so then how can I run script with mdadm?
I traid switch --program=/myscript.sh
Not working.
(Script is simple. Dump mdadm detail log to txt and sending it to my email. Script working)
// too far away outside of limit
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|