How's it going? having some trouble setting up my PowerVault 110T tape drive. I followed the instructions set in the documentation, but the set up just doesn't seem right.

It is an external tape drive.

I put the terminator on the tape drive (only SCSI device being used). On the other end, I connect the SCSI connector to the SCSI card. There are two slots, I connect to one and leave the other empty. I thought that it might need some type of terminator here too, but it doesn't show it in the documentation.

Here's my problem. When I went to the device manager, there were multiple drives listed. I then installed the drivers and 15 tape drives showed up. Is it suppose to be like this?

Thanks in advance