Hi

I have just installed the suse 10.0 in dualboot with windows.

The problem is that while the windows works fine on the resolution of 1024x768 pixles the suse refuses to turn up on that resolution making the monitor to go into a standby state with no display at all.

I have a HP55 Monitor.

Initially suse detected the screen resolution of my monitor as 1024x768 while installatoin and on boothing to it the monitor went into the standby mode.

Well this problem occurred from the initial boot. What i did was that i used the info on this forum and ran

sax.sh -l

It displayed the screen and set the resolution to 800x600. On logging on again i tried to change the resolution but the same thing happened.

The refresh rate taken by suse is 85Hz.

Well if the windows is running fine then i dont think there's a problem with the monitor. What could be the problem with suse and any possible solutions.