-
April 16th, 2006, 04:58 AM
#1
Senior Member
not able to set the refreash rate
hi!
I am having trouble with my LCD(monitor).
I have plugged in LG's L1750SQ, and I am running winXP professional, on pentium 4.
I have graphic card also.
the problem is that the refresh rate of the LCD is setted to default and there is too much flickering when i moved the windown on the screen.
I did go to control panel>display>>settings>advanced>monitor.
but the problem is that the properties button on that screen is disabled, and Screen Refresh Rate is set to "use default hardware settings".
I am not able to change these settings.
Any sort of help would be apprecisted.
Thanx.
U get What U pay for.
-
April 16th, 2006, 04:56 PM
#2
Good Day,
Generic drivers might do the trick most of the time or at least get us up and running. However for better performance you probably need the drivers specifically wriiten for your graphics card/monitor, etc. If you have an onboard graphics card the drivers can most likely be found with the installation CD that came with your Main Board. If it was an add-on, you can find them on the installation software that came with your card. If you didn't receive installation CDs, you can download your drivers online. I'd start first at the manufactures site for whatever hardware I was having an issue with. In this case I'd get them for the graphics card and the monitor. If that site doesn't have them or they are just too hard to find, you try an alternative site. One of those sites I am aware of is Drivers Planet
Anyway make sure your have all the appropriate drivers required for your hardware.
cheers
Connection refused, try again later.
-
April 16th, 2006, 05:08 PM
#3
Junior Member
What graphics card are you using???
-
April 16th, 2006, 06:10 PM
#4
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|