August 8th, 2007, 05:20 PM
I right-clicked on a drive I have in XP Pro, and it does not give any options other than NTFS.
August 8th, 2007, 05:41 PM
XP can be installed on either FAT32 or NTFS
You specify the file system during install...although you can convert an existing install from FAT32 to NTFS you cannot go from NTFS to FAT32.
AFAIK...some OEM installs use FAT32...with hidden system partitions for recovery tools....ACER laptops come to mind
How people treat you is their karma- how you react is yours-Wayne Dyer
August 9th, 2007, 03:11 PM
Yes when XP first came out it was virtually an OEM standard to install it with a FAT32 file system on laptops. It did not matter if it was the home version or Pro.
I am pretty sure that the Desktops with the Home Edition were FAT32 as well.
This really should be a fairly simple exercise? I have done it many times without real problems. Things to watch should be IMO:
1. The jumper settings on the HDDs. One should be Master and the other Slave, or both should be Cable Select (CS).
2. If you are using cable select then the master drive should be at the end and the slave in the middle of the ribbon cable. Even if you set the jumpers, this would still be my recommended configuration.
3. Go into BIOS, and on the first screen (usually "general settings" or something like that) check to see if the BIOS has detected both drives.
4. If the BIOS does not detect both drives, there should be an option to autodetect. Take that and the other drive should "appear".
5. If that doesn't work, then check that you have connected the ribbon cable right way round. It shouldn't be possible to get the Molex connector (power supply) wrong, but you never know.
There should be a thin red strip down the edge of the ribbon cable. This should face to where the power supply (Molex) plugs in. Assuming that the Molex has red, black and yellow wires, the red wires should face the red strip on the ribbon cable.
As you have a working machine, just make sure that the second drive is wired the same way round as the existing one
6. If you still have problems, try disconnecting the drives from the second EIDE slot on the MoBO and connect the second HDD there.
NB: I am assuming that these are both EIDE drives rather than mixed EIDE/SCSI.
If you cannot do someone any good: don't do them any harm....
As long as you did this to one of these, the least of my little ones............you did it unto Me.
What profiteth a man if he gains the entire World at the expense of his immortal soul?
August 10th, 2007, 02:32 AM
Thanks for correcting me on the cable placement of the drives, I had a brain fart.
"Somehow saying I told you so just doesn't cover it" Will Smith in I, Robot
By nataraj.asture in forum Hardware
Last Post: December 11th, 2006, 03:54 AM
By Death_Knight in forum Newbie Security Questions
Last Post: November 16th, 2006, 07:03 PM
By anban in forum Computer Forensics
Last Post: November 26th, 2005, 07:24 AM
By AsCenDinG in forum Newbie Security Questions
Last Post: May 25th, 2004, 02:23 PM
By gore in forum Newbie Security Questions
Last Post: December 29th, 2003, 07:01 AM