SnapGear SG300 Setup VPN to work with TheGeenBow Client

[zillah]

Hi

I have got this scenario ,,,ADSL modem Netgear router its LAN ip address 192.168.1.1 and one of its LAN port connected to a WAN port of SnapGear SG300 (192.168.1.2)

http://www.snapgear.com/index.cfm?skey=1556

LAN ip address for SnapGear SG300 is 192.168.0.1

I tried hardly to find any online documentation , the only site that I found was below

http://quark.humbug.org.au/publicati.../msg00038.html


I did my best to configure IPSec for SnapGear SG300 as below (I could not figure out where is my mistake):

1- Tunnel settings
http://img196.imageshack.us/i/tunnelsettings.jpg/


2- Local Endpoint settings

http://img269.imageshack.us/i/locale...tsettings.jpg/

3- Remote Endpoint Settings
http://img689.imageshack.us/i/remote...tsettings.jpg/


4- Phase 1 Settings
http://img691.imageshack.us/i/phase1settings.jpg/


5- Phase 2 Settings
http://img4.imageshack.us/i/phase2settings.jpg/



I used TheGreenBow VPN client utility ,,,,,my configuration as below :

1- Phase1advanced
http://img33.imageshack.us/i/phase1advanced.jpg/


2- Phase1 Authentication
http://img269.imageshack.us/i/phase1authentication.jpg/


3- Phase 2
http://img269.imageshack.us/i/phase2b.jpg/


By looking at those snapshots I would appreciate any hint or tip where I did misconfigure

Thanks