August 30th, 2010, 11:53 AM
August 30th, 2010, 05:15 PM
\"Those of us that had been up all night were in no mood for coffee and donuts, we wanted strong drink.\"
August 31st, 2010, 08:44 PM
I would run Spinrite on the disk. Chkdsk is probably hanging on a damaged sector. Spinrite will at least show the damaged sector and do a partial recovery of the sector to a new re-mapped sector. You'll still have to replace the drive but you should be able to get the data back. It's expensive and probably not worth doing if you can get the data off with the drive in the state that it's in. But it's good software to have in general for emergencies. I once had a client with a laptop that was writing to the disk when it was dropped from a table. It would not boot at all. After ~46 bad sectors were relocated and partially recovered, the drive booted up normally and all the data was able to be backed up.
September 3rd, 2010, 06:21 PM
The tool I would use is roadkil's "unstoppable copier". It works at a very low level, irrespective of drive format, and tries to rebuild the files at the byte level.
You need a spare drive or partition of the same size as the one you are trying to recover.
You might consider investing in SATA/PATA 2.5"/3.5" USB drive docking stations as well? If you do then be sure to get them with their own power supply, as the little caddies might have problems with big drives. They are pretty cheap these days, I just got 2 and I guess I paid around 20 bucks for the pair.
It has saved my (customer's ) butt more than once.
So long as the drive will spin up, it will have a go, so it doesn't matter if the drive has physical or electronic damage.
It is also FREE
By Internet Hacker in forum AntiOnline's General Chit Chat
Last Post: October 15th, 2002, 11:30 AM