SnapGear SG300 Setup VPN to work with TheGeenBow Client

[zillah]

What I did I configured the ADSL router in a bridge mode (modem only), now WAN port of sg300 has publich ip address x23.34x.6x.95 (unlike before)

I tried to follow the instructions in the link below (because I have got similar scenario except different router, document router FVS318v3 mine is SG300)

http://www.scribd.com/doc/3800513/Ne...-Configuration

The new snpashots for snapgear as below

1- Tunnel Settings
------------------
For the "Remote Address" textbox there are only three options (Static IP address , Dynamic IP address and DNS hostname address) we have to choose one of these three only, I chose : "Dynamic IP address" .

http://img697.imageshack.us/i/tunnelsettings.jpg/



2- Local Endpoint Settings
----------------------------
http://img697.imageshack.us/i/localendpointsettings.jpg/



3- Remote Endpoint Settings
----------------------------
http://img248.imageshack.us/i/remoteenpointsettings.jpg/



4- Phase1 Settings
-------------------
http://img248.imageshack.us/i/phase1settings.jpg/



5- Phase2 Settings
---------------------
http://img682.imageshack.us/i/phase2settings.jpg/



6- Finish
----------
http://img249.imageshack.us/i/finishu.jpg/



I tried to match every thing on "TheGreenBow = TGB" client to be same as the router (SA , key, ID,,,etc) but still VPN does not get established,therefore I could not find useful information from the logs

Please see the snapshot for TheGreenBow VPN client on the laptop

http://img81.imageshack.us/i/panoramatgb.jpg/


Thanks