win2003 event error

Hello im having some error on system event. There is a warning that says
Source: aac
Category: None
EventID: 4079
Descrition:
\Device\Scsi\aac1: PrintfToHost: String to large

In other description
\device\Scsi\aac1: ID(0:02:0); Recoverd Error [k:0x1,c:0x17,q0x3)

I belive im having some kind of problem on my raid.
I have a HP Proliant Ml150 server, with 4 SCSI 72GB Raid 5.
I have checked the light of the drivers on the server, and they are all green, so i think the drivers are ok, but there must be something wrong with the raid.
Does anyone had this problem? What was the solution?
Know a good RAID test tool?
Thanks

Its no biggie, take a look here:

http://support.microsoft.com/kb/272958/EN-US/

i have already checked that eventID but the problem is that the description doesn't match and its for windows 2000 and not windows 2003 server.
Thanks for the reply.

Dell has tools for its RAID....so I am guessing so does HP???

I recently had a disk fail and it showed up on boot..as the bios was loading the RAID controller.

The dell tool is installed in windows and monitors all the hardware.

MLF

well i thought that but im not using the HP Raid controller and add extra one that would support Raid 5. The Hp Raid controller on board doesn't support Raid 5 :(

Is there a diagnostic raid tool? Im still trying to find what is the cause of the error, i belive there's something to do with the raid.
I have rebooted but without errors in raid, so im kind of confused know :s

I suggest then checking with the vendor of the raid controller.

MLF

Already check it, only drivers firmware available , no tools for raid :(

Here is something i found:
http://www.eventid.net/display.asp?e...faport&phase=1

Says it could be high usage ... or power issues . I do have here a UPS compensating all the time the power.
Will try to check this out.
But if anyone have other ideas, please share.
Thanks

What is on the drive....users folders???

May be a synchronization issue as suggested.

Are you using Windows RAID configuration through the disk management utility ?

Or is it hardware RAID?? There must be some utilty before the OS boots that is used to configure the RAID before the OS boots.

Also ...how often does this error occur???

MLF

i have run teststtttttttttttttttttttttttttttttttttttttttttttttttttttt