Internet Connection but how???

[avols143]

Internet Setting...how???????
( post #1)

Hello, I am using Redhat Linux 9 with daul boot with WindowsXP. My internet is working properly in WindowsXP but not in Linux...
I have a ADSL with username and password and have an External Modem.
My LanCard is connected with this External Modem. I am trying to setup internet in linux from many days, but I can't.

** At booting time of Linux the following service is not working..

Setingup network interface [Ok]
Bringing up interface eth0 [Fail]

And in my Hardware Browser I have the following information in the Network Device.

Network Device: RTL-8139/8139C/8139C+
Manufacturer: Realtek
Driver: 8139too
Device: /dev/eth

And I checked the following commands to check Internet Configurations.....

[root@localhost temp]# insmod 8139too
Using /lib/modules/2.4.20-8/kernel/drivers/net/8139too.o
insmod: a module named 8139too already exists

[root@localhost /]# lspci -v
Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
Subsystem: Realtek Semiconductor Co., Ltd. RT8139
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at a000 [size=256]
Memory at ef010000 (32-bit, non-prefetchable) [size=256]
Expansion ROM at <unassigned> [disabled] [size=64K]
Capabilities: [50] Power Management version 2

[root@localhost /]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:FC:63:4E:6B
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:363 errors:0 dropped:0 overruns:0 frame:0
TX packets:327 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:22356 (21.8 Kb) TX bytes:21216 (20.7 Kb)
Interrupt:11 Base address:0x9000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:7935 errors:0 dropped:0 overruns:0 frame:0
TX packets:7935 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:541536 (528.8 Kb) TX bytes:541536 (528.8 Kb)

[root@localhost /]# netstat -i
Kernel Interface table
Iface MTU Met RX-OK RX-ERR RX-DRP RX-OVR TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0 1500 0....369 .....0 ..........0 .........0 .........327 ......0 .........0 .......0 .......MRU
lo ... 6436 0 ..9645 ....0 ..........0 ..........0 .......9645 ......0 .........0 ......0 ........LRU

Note:- I am using dots to hold values on correct position..

**************************

[COLOR=red]Can any body solv my problem........???????[COLOR=red]

[MrLinus]

Thread closed. You already have this going in another thread so there is no need to re-create this again.. and again.. and again...

You might also want to consider a visit to http://www.linuxquestions.org as they deal with Linux specific issues and probably can help you faster.