Hello Friends.........
I installed mplayer-gui, but I can't run into GUI mode....The following errors occurs.....

************************************************
[root@online root]# gmplayer
MPlayer 1.0pre3-3.3.2 (C) 2000-2003 MPlayer Team

CPU: Intel Pentium 4/Xeon/Celeron Foster 1898 MHz (Family: 8, Stepping: 2)
Detected cache-line size is 64 bytes
CPUflags: MMX: 1 MMX2: 1 3DNow: 0 3DNow2: 0 SSE: 1 SSE2: 1
Compiled for x86 CPU with extensions: MMX MMX2 SSE SSE2

Reading config file /usr/local/etc/mplayer/mplayer.config: No such file or directory *****(1)
Reading config file /root/.mplayer/config *********************(2)
Reading config file /root/.mplayer/gui.conf: No such file or directory ***************(3)
vo: X11 running at 800x600 with depth 24 and 32 bpp (":0.0" => local display)
Using built-in default codecs.conf.
Using Linux hardware RTC timing (1024Hz).
Falling back on default (hardcoded) input config
Setting up LIRC support...
mplayer: could not connect to socket
Failed to open LIRC support.
You will not be able to use your remote control.
SKIN dir 1: '/root/.mplayer/Skin'
SKIN dir 2: '/usr/local/share/mplayer/Skin'

*************************************************

Finally I receive the follwing messege in a GUI Windows..
Message: MPlayer interrupted by signal 2 in module: unknown

These files are not exist in the directories:
/usr/local/etc/mplayer/mplayer.config
/root/.mplayer/config
/root/.mplayer/gui.conf

Now how can I configure these files. OR Can you send e-mail with attachment these files
on my e-mail address............... avols143@hotmail.com

My be I can configure these files with my system....(I am using Fedora linux)

OR.......... Any other way to set these files.....................Thanks