-
May 14th, 2008, 12:26 AM
#1
Cisco VPN question
I was posed this question and I'd like to know what you think.
A customer network has one internet connection with one Cisco pix 501. They have two VPN tunnels configured: one is for remote clients and one is a site to site. The client are dished out a range of IPs that reside on the network proper (carved out of the DHCP range), say 192.168.10.100-150. The site to site gives access to the 10.1.1.0 network.
the question is: Can the remote VPN users access the 10.1.1.0 network directly or would they have to hop from one of the internal machines? In other words can I tunnel in and then out the same interface? I'm thinking not so much.
Let me know if the description is too vague or if you need other information.
Mankind have a great aversion to intellectual labor; but even supposing knowledge to be easily attainable, more people would be content to be ignorant than would take even a little trouble to acquire it.
- Samuel Johnson
-
May 14th, 2008, 07:21 AM
#2
Yes, you can. The VPN tunnel end point is actually a "virtual" interface. You can route traffic between these virtual interfaces. Doesn't matter if they use the same physical interface to communicate with the outside world.
Oliver's Law:
Experience is something you don't get until just after you need it.
Similar Threads
-
By Egaladeist in forum Security News
Replies: 0
Last Post: February 14th, 2006, 06:43 AM
-
By Negative in forum The Security Tutorials Forum
Replies: 12
Last Post: June 2nd, 2004, 01:09 AM
-
By Eversor in forum Hardware
Replies: 16
Last Post: October 25th, 2003, 11:42 PM
-
By smirc in forum AntiOnline's General Chit Chat
Replies: 6
Last Post: May 13th, 2002, 04:35 PM
-
By smirc in forum AntiOnline's General Chit Chat
Replies: 3
Last Post: May 13th, 2002, 03:24 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|