[gloworange]How to make good cable for Cisco certified equipment[/gloworange] .

1. Select the ammount of cable (CAT 5e UTP) 5 metre max for straight through, 3 metre max for crossover.
2. Remove an inch of cable covering. Using a croping tool (blade section for clean cut).
3. Ubtwist the pairs. Stretch out using a pencil or pen.
4. Place in order of: Pin Colour
1 White/green (Has stripes of white and green).
2 Green
3 White/Orange
4 Blue
5 White/Blue
6 Orange
7 White/brown
8 Brown.

5. Clip wires to even end length.
6. Get the jack RJ45 and insert cable. the cable ends must touch the end of the jack.
7. Check the cable order and the shield enter the jack.
8. Crimp using the larger tool.
9. Repeat srep four for straight through.
Crossover cable Pin Colour
1 White/Orange
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
10. Repeat steps 5-8.
11. Test using cable tester.