I'm a total noob to linux.

I have an HP EN1207D-TX PCI 10/100 Fast Ethernet Adapter that runs fine with winxp(of course).

My system is a 600 mhz celeron running 256 mb.

I have installed redhat 9 with kernal 2.4.20(thats what it says on the box).

I've tried using network config to pick my card(or closest to it) on the list; none work.

On the startup screen when redhat boots I see there too that any eth0, eth1 or whatever fail to intialize.

I connect through dhcp.

I've tried looking for drivers and haven't had much luck.

Even if i got a driver that would work, I wouldn't know how to install it unless someone specifically instructed me.

I have read some linux doc's and I have concluded it to be a driver issue.

I have considered just buying a new network card off ebay or going to salvation army and pulling one from an old system but i would like to get mine to work if possible.

Would It be possible to write a driver for this card or do you need exclusive information from HP?

I Sincerely thank those that attemp to help me.