So, a couple of days ago I got some old equipment in to mess around with. I got 4 bases, 3 hubs, and 1 cisco Catalyst 2950 series 24 port switch.

I've been wanting some cisco hardware to mess around with for a while, so I was pretty excited. I have no clue about cisco hardware, so I figured I'd just plug it in and go from there. Anyways, when I plug it in, all the leds flash green once, then the syst led comes on amber and the stat led blinks green a few times, then the stat led goes off completely and the util led comes on green for a few seconds, then the syst led starts blinking green and it does that indefinitely. The syst led is on and amber the whole time until it starts blinking green. I haven't found anything online so far about the syst led blinking green, so I was hoping someone here might know of something I can do to revive this thing. I assume it's old because everything from where I get this stuff is old. So perhaps it's just dead. But I'm hoping that's not the case. Any help would be appreciated, thanks.