i have put together my new comp i have a abit KD-7 RAID motherboard
AMD Athalon 2000 XP processor 2 80 gig 7200 rpm western digital HDs

there are 4 40 pin EIDE slots 2 of which are regular other 2 are for mass storage and are yellow these can be used for raid

well i connected all power and ribbons booted it up
the bios couldnt detect the HDs but the raid i was able to set up an array
i set it for raid 0 for stripping performance

and all looked good
but when i rebooted bios didnt see the hds

i have the hds set to cable select
no master no slave
basicly because they were in 2 different slots
i tried to look into this further but no luck

anyone have any
by the way i have set it to normal in the 1 and 2 slots till i can use the raid and 3 and 4 slots

thanks