I did some research and this is what I could come up with. Hope it helps :


"There are ways to make it more difficult for your visitors to read your source code. Here are some of them:

(1) Adding dozens of carriage returns at the top of your HTML page

This one has fooled me a couple of times. All you see is a lot of blank space - but just keep scrolling down and you'll find the source code.

(2) Using frames

When you try to view the source code of a page using this technique, all you see is the first ten or fifteen lines of HTML. But just save the page to a folder on your hard disk and then look for a sub-folder where the images in that page were saved to.

In the sub-folder you'll find an HTML file that contains the source code you were looking for. Again, this won't fool experienced users, but it's worth a shot. Here is the code:
http://www.ezine-writer.com/framescode.html.

(3) Disabling Right Click

This is an old trick and experienced surfers know how to get around it. Here it is anyway - a script that disables Right Click:
http://www.ezine-writer.com/rightclick.html

(4) Disabling View Source

I searched high and low for a script that disables 'View Source' in the browser menu bar, and couldn't find one.

Here is a script that is supposed to disable 'View Source' - I tried it out in my browser (IE 6.0) and it didn't work, so perhaps it only works in older versions of IE:
http://www.ezine-writer.com/no-source-code.html

(5) Encryption plus frames

This is a technique that will work on all but the most experienced web surfers. Here is the code for doing it:
http://www.ezine-writer.com/hidesource.html

I've created a copy of my index page using the above technique - if you click on View Source, all you see is a jumble of characters:
http://www.ezine-writer.com/encrypted.htm"

by: Michael Southon