Seems I'm a bit confused on my terms here...what I did was took out the battery for about 5 minutes, and put it back in, tried to boot the system. And I also used the jumper option to clear the CMOS.

The siren started after I stuck the new PSU in, and hooked it all up, and tried to boot for the first time.

As for my phyiscal setup, 2 HDDs, a DVD-rom drive and a CDRW drive. With my old PSU, I only had enough juice to run one at a time. So I chose the CDRW since I burn more CDs than DVDs I watch. I have both HDDs in IDE-0. 80gig as Primary and my 120gig Storage one as slave. And on IDE-1, I had my CDRW as a primary(being the only drive using IDE-1). All devices are assigned in a working order, Since I was able to install my PSU without having to unhook any IDE cables for the HDDs and CDRW, so the same setup was working with the old PSU.

Tried the system with only Video Card, 1 stick of memory in each slot. As for my front panel, All I have hooked up normally is my Power button and my reset button(Pretty basic tower).