When I type ifconfig I get my loopback stuff and i get eth0. It is frustrating b/c when I ping from 192.168.0.3 to 192.169.0.4 the activity light comes on both and the hub blinks and shows activity.Thanks for the help Phat_Penguin but I think slarty is right. All hosts were allowed by default. Right? Another thing-when I turn one of the computers on the activity light automaticly turns green on the hub, even before networking starts up. On the second it only comes on when networking starts. Would this have any effect or cause a problem? It is another question that has plagued me.
Here you go Shrekkie-
eth0: 3c509 at 0x220, 10baseT port, address 00 00 76 2a 6f 02, IRQ 11.
eth1: 3c509 at 0x300, 10baseT port, address 00 04 76 2f 6f 46, IRQ 10.
eth0: Setting Rx mode to 1 addresses.

-libertie